First Dyno Run
So I finally decided to take the car in to the Dyno before I mod much more. I am pretty happy with the results.
Run 1: "Baseline"
Procede Map 0
Procede Map 2 15.5 psi
0% ignition correction
110 octane race fuel
As you can see in the Dyno and on the log, a little over 4100 RPM's I had a big timing pull (either knock or the DME reacting to the high IAT's). My IAT's were going through the roof with the stock IC, so when I get my new IC the graph should smooth out a little bit. Overall I am pretty happy with everything.
Last edited by jdbretz; 07-22-2011 at 02:25 PM.