H&R Springs - Ground to Fender Height
To those of you running H&R Sport and H&R Race... could you measure your front and rear GROUND to FENDER edge heights? (preferably e92)
I want to give my car a stance in between the two... for those of you who are going to say do it by eye... my eye is telling me to go way too low so I need to make some adjustments. I know my buddy with H&R Sport has no issues with scraping but my buddy with race often scrapes his front lip... so I would like to go somewhere in between.
Currently this is how my car sits:
Rear - 24 inches
Front - 24.2 inches
My front is a bit higher than my rear so I was thinking of going about either 0.3-0.4 inches lower up front or maybe higher in the back to give the car a nice rake.
JB4 / OSS Angel Eyes / Downpipes / F1-Racewerks FMIC / Custom Meth Kit / BMS DCI / ER Chargepipe / HKS BOV / BMS Meth Elbow / BMW Performance Exhaust / Carbon Fiber Inlay Quad Tips / 19" Miro 111 / Front Aero Lip / M3 Sides / VRS CSL Trunk / Mtech Rear / DD CF Quad Finned Diffuser / LCI Tails / BBK / Smoked Reflectors / F1 Euphoria LED Interior / License LED's / GT 5000k Corners / 5000k HID Fogs / Air Scoops / LED Turn Signals / FK Silverline Coilovers / HPA endlinks / Vibrant Resonators / Osram CBI 5000k D1S