Thread: Cant see much
View Single Post
      09-12-2011, 02:52 AM   #1
marcm
Second Lieutenant
 
marcm's Avatar
 
Drives: E90 325d
Join Date: Jan 2007
Location: UK

Posts: 286
iTrader: (1)

Cant see much

Hi All,
I've been trying to do a bit of CAN sniffing on my 08 E90. I have a canbus analyzer and I have connected to pins 6 and 14 so I can see the data.

From what I have read I should be able to see the PT-CAN data but all I can see are the following messages:

Started: 08/09/2011 21:24:29
RX (HEX),130,5,C1,42,FF,FF,FF,,,,425.381,0.1,
RX (HEX),130,5,C1,42,FF,FF,FF,,,,0.915,0.04,
RX (HEX),130,5,D5,42,FF,FF,FF,,,,0.965,0.05,
RX (HEX),130,5,C5,42,FF,FF,FF,,,,1.855,0.07,
RX (HEX),130,5,C1,42,FF,FF,FF,,,,14.677,0.1,

C1 = Ignition ready
D5 = Engine starting
C5 = Engine running


I have tried to send a request for PID 0 in the hope that might trigger the bus into showing more data. I think the analyzer sent:
0x7DF, 0x02, 0x01, 0x00

But I get nothing not even the designated ACK with the bitfield.

Is there anything else I should be doing or something I could try ?

I am going to get a scope on the bus and see if the analyzer is actually transmitting the message, I'm sure it is as it can see the ignition status message.

Any help/insight/tips greatly appreciated.
marcm is offline   United Kingdom
0
Reply With Quote