View Single Post
      10-13-2011, 01:16 PM   #38
subieworx
Lieutenant
7
Rep
403
Posts

 
Drives: 07 335
Join Date: Jun 2010
Location: Ohio

iTrader: (1)

Thank you and please understand that I am far from a suspension noob and as such tend to over simplify my comments so as not to potentially confuse the less knowledgable. I was simply trying to make points in that one should not lower the car too much and that the rear shock housings need to be shorter. This is especially true given the design of most coilovers for this car as without shorter housings it is very difficult to properly tune the suspension given the factory design constraints. There is no coilovers out for this car that I am aware of that uses the bump stop in the same manner as oem which leads to a necessity of shorter shock housings or higher ride height for additional compression travel.