Originally Posted by torque
So I went back outside and just removed the module and it is now sitting on my living room table. The meter inside reads just past the half way mark (about 60%). As I started the car back up everything was fine except for the SES light but no codes on the dash or iDrive.
I emailed Burger a few questions and there responses were incredibly prompt. So kudos to Burger Tuning
. I didn't get a chance to snap a picture as to if everything was installed correctly but I am mechanically inclined and it is basically a plug&play so I think it's just a communication error.
Hoping to get this Boot Camp but it'll take me a minute since I am not a huge computer nerd and just surf the net and basic shit... so bare with me folks.
I'm curious to see how this turns out for you... hopefully it turns out well!
.. just ordered my JBD and CAN tool tonight as well!