View Single Post
      01-04-2012, 08:13 PM   #4
loweran
New Member
 
Drives: 06 e90, 04 e60
Join Date: Jan 2012
Location: Centex

Posts: 10
iTrader: (0)

I am in the middle of trying to replace my tensioner pulley. The belt was making a noise, so I checked it out and found the head of the torx bolt has snapped flush with the assembly. I thought it would just slide out, but it only comes out about a quarter of an inch and hits something. Does the assembly slide straight in, or does it need to be angled to install it? Also, did you remove the fan shroud? Looks like mine has a transmission cooler that is attached to the bottom of the shroud with a torx screw. Real tight in there so going to take some doing to get it loose to remove the fan.
Here is a [rather large] image:


Last edited by loweran; 01-04-2012 at 09:28 PM. Reason: added photo
loweran is offline  
0
Reply With Quote