Originally Posted by afsar
Thanks for the response. What do I connect to the input, full range front channels L/R or make it 4 channel stereo as it was in CCC before? Which channels will they go on H660?
Leaving PDX5 full range? even for the sub?
Have a look above we should have covered it.
Not "full" as in introducing new freq range on the PDX-5 after H660 x-overs have been set, like setting the LPF (PDX-5) on your SWS-8 at 200Hz if you want them to run at 50Hz. But "full", as in if you want them to run at 40Hz (which is the max LPF on H660) you can set your LPF(PDx-5) to 30Hz since it won't go that low anyway(H660), and same for the HPF for the mids this won't go lower then 200Hz so you can leave them on say 150Hz. And then if you want to change it to say 220Hz, you can do it on the H660.
Either way, you will be dictated to by the H660, since it's HPF and LPF won't go as low your Amp's Filters.