View Single Post
      01-25-2012, 07:36 PM   #33
Brentis
Private First Class
 
Drives: BMW 335i
Join Date: Oct 2011
Location: Frisco

Posts: 143
iTrader: (1)

Am I the only person who notes that gravity "spun" wheels are in most all scenarios better than low pressure cast? Think about it... The g's and vacuum created with a centrifuge-like device would be much greater and I would think also more evenly.

Am I wrong?

Quote:
Originally Posted by crimsone90 View Post
Forgestar, If you are saying that Forgestar have a flow-forming machine in their facilities I would schedule an appointment with them and will try to make it there next week.

Advan, please see attached.

VMR, please see below:

From Peter himself. Source: http://www.e90post.com/forums/showthread.php?t=14304 Post: 12

I have also heard Peter himself state this personally.



Tom @ EAS, VMR largest distributor regarding the new V713 at M3Post. Source: http://www.m3post.com/forums/showthread.php?p=4813986 Post #15.



Expect all these posts to be edited/deleted after I post them here so check them quick.
Brentis is offline  
0
Reply With Quote