View Single Post
      01-30-2012, 06:14 AM   #13
sieras5__
Banned
 
Drives: E60
Join Date: Jan 2012
Location: europe

Posts: 14
iTrader: (0)

Quote:
Originally Posted by JunkStory View Post
Please help me. I recently replaced the front brake pads because they were worn, but noticed that the sensor was still untriggered. I did not buy a new sensor, but I did not want to reuse the old one either, so I wrapped the sensor portion with electric tape and zip-tied it somewhere inside the wheel well without inserting it back into the brake caliper.

I put the wheels back on, and went ahead to reset the CBS. DING! The SES and brake lights are on. What have I done wrong? Do I really have to plug the sensor back into the brake caliper?
There are two options;
deactivate the sensors with a special program
connect resistance, instead of the sensor,
in any case, better to put the new sensor, it is not expensive.
sieras5__ is offline  
0
Reply With Quote