Originally Posted by xxxjecxxx
just in case you can't get WinKFP to work.
you won't be able to read every module with v45. Especially FRM or NFRM.
Sometimes (a lot actually) I find that even after program all other modules with v44 or v45, I have to go back to v39,v41,42 to program NFRM.
Again, just suggesting the way I would do it. Good luck!
Originally Posted by DESI4life10
But FRM 2 module has more values than frm 1...so that method won't work well.
OP, you can probably get away with not needing the indent number. You just need to know what family it's from (which should have stated on the FRM module itself FRM pl2 or something). This will be used when you flash the module in winKfp.
Thanks guys for the suggestions. After messing around in INPA I did find the ZUSB number by choosing E90, then when the menu list came up the top option was selected (first option listed above engine, transmission, chassis etc.), then I selected 'Functional Jobs', and finally I selected F2 (I think) to see the identity # of the different modules in my car.
I was able to use winKFP to program the FRM2 and tools32 to write the VIN using the script fvin. BTW DESI, in winKFP my module was under the FRM2 ecu type when I entered my ZUSB, but I did see the FRMPL2 type there as well...
OK, so now here is my problem, FML...I have coded a few things to the .MAN file for welcome lights, but nothing has changed. When I lock my car, the regular lights still flash twice and when I unlock the doors, only the door handle lights and interiors come on. I have attached the .MAN file that I coded.
Any ideas???? I've spent countless hours trying to figure this out.......
here are the welcome light values to save time from looking at the man file:
Any ideas???? DESI, I know it's a pain, but if you could help me out and send me your .man file of your NFRM so I can compare them that would help me out so damn much. I've spent countless hours trying to figure this out.......