Originally Posted by Alan_S
I have managed to activate the bluetooth in the Mulf2 HI module factory fitted to my 09 335i (US SPEC). The car has 6FL but no phone prep or navigation. Using the resorces available on this forum and at ************** i downloaded the tools and was able to get everything working in the module using NCSEXPERT and a cable I purchased. I still have the MIC wiring to do and I have to connect the bluetooth antenna, however if i place the phone in the trunk it will pair. I can also dial and recieve calls in the car. The only thing that was a little strange with my car was that I did not have a 2RAD module but I had a 2URAD module, I tried to code that module but got an error message. I shut the car down for a few mins and started back up, the phone menu was then available. So I just had to modify the vehicle order and write to CAS and NFRM. Its fairly straight forward once you get everything on your laptop set up and working.
were you able to hear the calls from the speakers without the mic installed?