View Single Post
      04-12-2012, 10:49 PM   #14
BQTuning
Banned
United_States
469
Rep
4,392
Posts

Drives: 2012 Z4 sDrive35i M Sport 6MT
Join Date: Nov 2010
Location: bq@bqtuning.com

iTrader: (0)

Part 2

Part 2

I have sealed up the intake which turned out really good. I used a high resistant thermal insulation rubber tape and a caulk gun.The insulation tape is used in plumbing to wrap heated pipes.

These are the things I bought at Home Depot, except for the pot pie - my dinner



Turned out all I needed was the caulk gun, the insulation rubber tape, and of course my pot pie to eat.



I used the caulk gun on the turbo external part of the inlet that is inserted into the air box. After it has hardened I will cut the residue.



Next I started to seal up the air box cover with the insulation tape and the top part of the box



All is ready tomorrow for installing right after I dyno with the stock intake. After installing I will be heading out the Palm Beach International Race Way for some test runs and for the DME to adapt.

Click HERE to go to part 3

Last edited by BQTuning; 04-21-2012 at 01:00 PM..
Appreciate 0