View Single Post
      04-20-2012, 11:42 AM   #12
Doyle
Hellafunctional
 
Drives: 335xi
Join Date: Nov 2010
Location: N/A

Posts: 426
iTrader: (2)

Not really. With the 7" spring I had 2 threads left until the lower perch ran out of adjustment (check out my review thread for pictures). I made contact with the bumpstops maybe 2-3 times. With the 6" springs I haven't bottomed out at all.

I'm running a pretty stiff spring up front (450#) as well as MUCH lighter wheel (<19# for 18x9.5), though. My shop was adamant about not putting anything lower than 450# up front. I suspect this is the reason (lots of weight to control, and little compression travel).
__________________
Go: Cobb S2+, Big Tom FMIC, CP-E DP & DCI, Royal Muffler, AR OC
Turn: TC Kline/Swift SA, Vorshlag Plates, UUC Front Bar, H&R M3 Rear Bar, VAC endlinks & spacers, Forgeline 18x9.5/NT05 265 Square
Stop: Endless MX72, Stoptech Rotors/Lines, Motul RBF600
Doyle is offline  
0
Reply With Quote