Looking to pick up a new set Front/Rear Geomet Drilled/Slotted Rotors. Confusing as there are a couple different part numbers for the same size and config?
I have 2009 BMW 328ix E92 N52 Build Date - 2/2009
As far as I know, the fronts are 312x24 & the rears are 300x20
> Please reply with the correct part numbers I need for drilled/slotted geomets for my app.
> Also, due to the slots/holes - will these tend to wear the factory pads down quicker?
> What aftermarket pad do you recommend for only street driving, pretty much same cold/hot bite, but with lower dusting than OEM pad (if that's possible)?
2009 328ix E92 Cpe//SGM//ACS Roof Spoiler//MTech Aero Lip+Trunk Spoiler//M3 Side Skirts//CF Roundels-CF Grilles//M3 Novillo Interior//Perf Shift Lever+Boot//MPerf DCT Wheel//M3 GT3 eBrake Handle+Boot//ACS Pedals//M3 Mirrors//LCI Tails w/LUX Rev//LUX H8v3 AE/MTec 6000K D1S/HPB HID 6000K Fogs//HPB LED Interior//RPI Scoops//CF Euro Airbox+Underhood Hsgs//K&N//BMW PE//MTech Rear Bumper-iS Sport Diffuser//MFD Strut Brace//PBX//BMW 193M's+Kumho 4X
Last edited by 1QuikWS6; 05-11-2012 at 04:33 AM.