View Single Post
      05-11-2012, 10:16 AM   #6
BimmerPost Supporting Vendor
ECSTuning's Avatar

Drives: Independent Tuning Specialists
Join Date: Jul 2008
Location: Ohio

iTrader: (18)

Send a message via AIM to ECSTuning
Originally Posted by 1QuikWS6 View Post
Looking to pick up a new set Front/Rear Geomet Drilled/Slotted Rotors. Confusing as there are a couple different part numbers for the same size and config?

I have 2009 BMW 328ix E92 N52 Build Date - 2/2009

As far as I know, the fronts are 312x24 & the rears are 300x20

> Please reply with the correct part numbers I need for drilled/slotted geomets for my app.

> Also, due to the slots/holes - will these tend to wear the factory pads down quicker?

> What aftermarket pad do you recommend for only street driving, pretty much same cold/hot bite, but with lower dusting than OEM pad (if that's possible)?
For your 328xi the drilled and slotted rotors for your car are the ones found HERE. Also just for good measure the slotted GEOMET rotors for your car can be found HERE.

Slotted or drilled or slotted and drilled rotors will cause slightly accelerated pad wear, but it's negligible in most cases. It's not something I typically worry about.

For street pads I'm a fan of EBC Greenstuffs, they are a mild upgrade from the stock pads in terms of bite, are lower dusting, and under normal driving conditions they shouldn't experience fade. HERE is a link to the Greenstuffs for your 328xi. I have a slew of other options avaible HERE.

Originally Posted by RaihaX View Post
Any for 1er?
At the current time I do not have a complete offering for the 135.