Originally Posted by DESI4life10
If you want to get yout xenon highbeam working, please follow the link above and read the section of enabling the bi-xenon feature. Make sure your halogen high beam is not set to DRL mode (code it off or change it to your AE).
If you do decide to do the bi-xenon feature (xenon high beam), make sure you code the PWM_ANST_FL_BIXENON lines according to the DIY.
This will allow you to get your highbeams back when you do the conversion.
I will be retrofitting non-adaptive lights, so I will not have any halogen bulbs there, just bi-xenon. I understand that wiring changes for bi-xenon is required, but do I still need to make changes to PWM_ANST_FL_BIXENON ???
Also, if I make sure that high beam is not set to DRL mode, will I have a problem with xenon stutter not working properly at 6V? Or should I be ok, since high beam will operate at normal voltage (12V)?