Originally Posted by DESI4life10
Yes you still need to make the changes to the line as you will use lose your highbeam.
And by not shutting the drl off, you will hear a humming noise from the shutter and it will turn off once you flash the high beam. It will happen at every startup until you flash it or if you turn the DRL off.
Do you have any suggestions about 3 little LEDs (pin 7 I believe)? Should I just wire them to run together with AE (pin 1)? Or perhaps I should just keep them off? Also, what is the best method to make wiring changes inside the housing? Can I get the actual socket (for wiring harness) out of the housing, so soldering could be done, or should I just splice actual wires?