View Single Post
      05-21-2012, 06:18 PM   #76
Elliott@DetailAddict
Brigadier General
United_States
81
Rep
4,448
Posts

 
Drives: E90
Join Date: May 2011
Location: Santa Clara, CA

iTrader: (0)

Quote:
Originally Posted by makkan00 View Post
Thanks Grant.

Just to confirm how we are coding.
Load NCS expert.
Load FSW PSW MAN profile.
F1--> F3
Followed by selection of E89.
Select CAS from ECU menu.
Press back.
Select FRM ecu and read ECU.
When it is read, I can recode with you file, and write it to my car FRM.


As I said, after adding your files to my car, same file if coming out if I read FRM module.

If you say, it has to do with my coding setup, what can I do to try something different?

You are champion, but unfortunately I am stuck with this.

I think, I will try resetting the whole FRM with blank MAN file to see, what I generate from my car, and re-code it with your file again.


Thanks and really appreciate your input and will let you know if I get success.
Make sure after you select the FRM module you select F5 (basic functions) and pull in the FSW MAN file. then F2 change job and select SG_Codrien and execute job.

Did you follow the DIY to setup your FSW Profile "to the T"?