Originally Posted by Grant@DetailAddict
Oh! I was under the impression the only changes being made were the 3 you listed a few posts back.
I'll have another look through the file at lunch for you.
I can see how frustrating this must be for you!
Finally, I am glad that you get it.
Those three lines are the only difference to your file.
Basically if I write you file to my FRM, it get written to FRM.
But if I extract it from my system, it comes automatically with addition of those three lines.
I also reset the whole module with expert mode, and tried with your file, but at the end, I still get the error and final file comes with the addition of those three lines.
I am not sure if LED bars on my lights are faulty or bulbs.
I have changed few bulbs but results are same.