View Single Post
      05-23-2012, 09:53 PM   #134
Virterm
Private First Class
 
Drives: 328xi
Join Date: Mar 2012
Location: Ottawa, canada

Posts: 137
iTrader: (0)

Quote:
Originally Posted by davidzf View Post
hey dud,thank you for reply

I jump the pin5 to pin6 inside the headlight

add GND on pin2

nothing more

...

buy a volt meter or go to the dealler,Its a
Just get an inexpensive multimeter. What I would suggest to do is as follows:
Disconnect the lights, or better just the AE bulb ( or cable) and see if the error goes away. Then, measure the voltage between ground and pin 1 (AE). Also, I would suggest to compare resistance ( ohm meter) on both lights AFTER disconnecting them. Measure between pins 1 and ground ( with and without bulb but WITHOUT POWER CONNECTED!!!!)
This way we should be able to see if the unit is even trying to power the AE and also if you have short in the housing.

Last edited by Virterm; 05-23-2012 at 10:25 PM.
Virterm is offline   Canada
0
Reply With Quote