View Single Post
      06-18-2012, 12:49 AM   #20
Casca
Captain
 
Drives: E90 6MT
Join Date: May 2010
Location: California

Posts: 618
iTrader: (0)

Quote:
Originally Posted by demented328 View Post
Also had to bend the clips for the bulb holder. Haven't figured out a back cover cap but doesn't look hard.
Everything is pretty much back together with the exception of the lens cover. Will put that on once I make sure everything is good. For the back, I got this rubber end cap from The Home Depot



Cut the top off the Depo cap


Glued the rubber cap on to the original depo cap I just cut


Glued a length of bike tire rubber innertube on to the top of the cap I cut off and then glued that on to the original depo cap+rubber cap


Will zip tie the rubber innertube to seal that end once I run the wires through after everything is mounted. Gives enough extra space to clear everything, without being too big.
Casca is offline  
0
Reply With Quote