Originally Posted by Technic
When the MS-8 plays a sound thru each speaker (front right, front left and so on) to test its speaker output configuration just make sure that each sound corresponds to each speaker as set below:
For the front 2-way configuration, Front Left Hi would be CH1, Front Right Hi would be CH2, Front Left Lo would be CH5 and Front Right Lo would be CH6. You may have a configuration problem there.
Check also the the front 2-way crossover settings:
- the first filter setting is a subsonic filter, use 40Hz to 50Hz at 18 or 24dB if using the OEM woofers.
- the second setting is the Hi/Lo crossover point, use 150Hz to 200Hz at 12 or 18dB
The problem with the front 2-way setting is that the MS-8 may have difficulties localizing the underseat woofers during calibration so the bass/midbass could be mediocre, especially when the MS-8 powers the woofers directly.
To fix that without adding a separate amp for the woofers or a sub then set the OEM woofers as 2 Subs in the MS-8. The subsonic would be 50Hz at 24dB, and the low pass could be 150Hz or 200Hz, whatever sounds good to you. Then the fronts filter will be set automatically once they are set at 1-way. The bass will be "restored" to the OEM woofers this way.
Then try calibration volumes between -20dB and -25dB. That should do it.
Thanks Technic! I am at work now but cant wait to try once I get home. I know it will only improve once I get it setup better.
Do I have to calibrate for all seats or just my drivers seat? or just driver/passenger?
I only have people usually in the front.
- Also is it normal for the rear to have almost no sound coming out of the speakers?
- I think your setup said rears = NONE and my rears are now configured as sides ( assuming side surround for Logic 7 )