View Single Post
      07-16-2012, 04:54 PM   #409
supremepower
BimmerPost Supporting Vendor

 
supremepower's Avatar
 
Drives: 991 Carrera S, M6, Noble M12
Join Date: Jun 2006
Location: so cal

Posts: 2,024
iTrader: (12)

Send a message via AIM to supremepower Send a message via MSN to supremepower Send a message via Yahoo to supremepower
Quote:
Originally Posted by plokij View Post
Supreme Power? Hello?

I'm taking the car back to the installers today to make sure the top nuts are tightened properly. Is there anything else I should mention to make sure the install is correct so that the noises go away? Could the little piece of rubber be causing this? Should it be removed?

Also, I spoke with Koni NA regarding the shortened stroke range of their sport (yellow) shocks due to the lowering perches and my EPK springs. Their response is that they will be fine. As a preventive measure (so that the bumpstops don't prematurely wear out) I will be replacing my OEM bumpstops with the shorter ones from the M cars.
There should be no noises at all. Did the installer put in the dome washer w the rounded side pointing up between the spring top hat and the top strut mount?

#7 in the pic

and #9 rubber piece is not used w the aftermarket perch

__________________
SupremePOWER
1025-B Ortega Way - Placentia CA 92870
714 632 1951 x225
eric@supremepower.com
Eric Nareshni
supremepower is offline   United_States
0
Reply With Quote