View Single Post
      07-24-2012, 02:29 PM   #19
MrQuickR1
Second Lieutenant
 
MrQuickR1's Avatar
 
Drives: 2011 328i
Join Date: Jan 2012
Location: NJ

Posts: 284
iTrader: (0)

Quote:
Originally Posted by luckydawg003 View Post
I'm working right now at replacing my Valve Cover Gasket and my Starter.

OP: How did you get the eccentric shaft sensor gasket off of the valve cover? I can see with the new one that it is threaded on there, but for the life of me cannot get it off and I don't want to keep pulling pieces of rubber off with my needle nose pliers for fear of damaging my valve cover. Any advice.
Thanks.
Sorry for the delayed response, It just pops out. It doesn't screw in.
On replacing it, you just snap it down into place
MrQuickR1 is offline  
0
Reply With Quote