Originally Posted by johmei
Thanks for a great DIY!
Getting ready for cleaning and switching the solenoids as I've gotten exhaust vanos code a few times when I get off throttle after 3,4 and 3,4,5 WOT pulls.
What screw is holding the solenoid in place? Looks tight, best way to reach screw?
This is a 10 minute job, take off snorkel and there is a 10MM bolt holding the vanos retaining clip to the block.
JB4 G5, WEDGE flash, Walbro 455 LPFP, HFS-4 meth kit 4-AN SS lines, BMS OCC, RB turbos W/3.5 N20 sensor, RB valve, BMS DCI, 3" AR Dps, Custom OC W/ SS lines, ER FMIC, ER CP W/HKS BOV, M3 control arms W/upgraded bushings, M3 Strut Brace, M3 front sway, Meyle HD tie-rods, HPA rear toe arms, Wavetrac LSD, DEFIV kit, Ohlins R/T Cois W/12KG swift springs, Power-Flex subframe bushings, stoptech rotors, Rogue Tranny Mounts, Morr VS8.2 rims 245/295