View Single Post
      07-30-2012, 10:39 AM   #40
ECSTuning
BimmerPost Supporting Vendor
ECSTuning's Avatar
United_States
203
Rep
6,686
Posts


Drives: Independent Tuning Specialists
Join Date: Jul 2008
Location: Ohio

iTrader: (18)

Send a message via AIM to ECSTuning
Quote:
Originally Posted by R 4 5 T 4 M 4 N View Post
ETA of October on the rears? Say it ain't so!
Currently we are re stocking. The coating and machining processes take some time. Sorry for the re stocking daily.

Quote:
Originally Posted by Route 16 View Post
About the drilled rotors, when you say machined, the holes go through the other side or they only drill dimples so to speak. And the difference between cast rotors.
The slotting and drilling are machined in, this is done after casting but before GEOMET coating. They are not dimpled they are fully drilled.