View Single Post
      08-02-2012, 11:31 PM   #1
mastamind518
New Member
 
Drives: 07 328i
Join Date: Dec 2011
Location: Florida

Posts: 22
iTrader: (0)

Help! Coding Newbie

I have been trying to start coding for a few weeks now. But I keep getting stuck at one step (step 13 from DIY) so I thought I'd finally ask for help.

I followed all steps in the NCS DIY from the sticky. I get to the step where I have to connect the cable to my car and the ignition circle in INPALOAD is supposed to turn solid. But it doesn't turn solid. Battery is solid black. I made sure com port was set to 1.

I triple-checked all the steps to make sure I did them all. Only discrepancy was when going into the driver properties and some of the options were missing. But another thread updated me on that issue.

Is there something specific I should be checking? Does it mean my cable is bad? I bought the recommended one from eBay.
__________________
Upgrades done:
Dual Exhaust, LCI E90 Trunk/taillights, Escort 9500i, 20% Tints

Upgrades Pending:
Wheels, Xenon Headlights/Angel Eyes
mastamind518 is offline  
0
Reply With Quote