View Single Post
      08-08-2012, 11:19 AM   #1
morski
Enlisted Member
 
Drives: X1 2.0D X Drive
Join Date: May 2012
Location: North West UK

Posts: 33
iTrader: (0)

Hi,
Im about to do a retrofit of cic sat nav in an X1 (same wiring as E90) with no pre nav or bluetooth etc. having removed the original pro radio there is no fibre optic MOST on the loom but the cic has one. Should i simply make a new fibre loop and fit it into the loom connector?

Also can someone post up or send or even direct me to where to tap into the JB for the controller CAN wires rather then from the back of the unit. Also the pin out wiring for the controller. I know its a simple 4 pin power/ground/ CAN H/ CAN L

Thanks in advance

Last edited by morski; 08-08-2012 at 12:27 PM.
morski is offline  
0
Reply With Quote