Originally Posted by makkan00
That explains it better.
Are we using NCS expert in expert mode (to write it to default) or any other profile in this case?
Also why did you change nettodat file and not PSW.....TRC?
To be honest i'm not sure but i believe it is the only way to make this specific code to stick if the CIC is rebooted. I just followed the steps in both the V2 and V3 DIY pdf's and this is what it said to do. A more experienced coder should be able to explain why the nettodat file instead.
I used my default PSW FSW profile i created in expert mode to write it back but it was using different steps then what is typically used when writing the FSW_PSW.MAN file back.