Originally Posted by Dave W.
Originally Posted by Zebra99
Stupid question, but isn't there a way to get that piping run straight down near the ground, but still safely under the plastic undercover?
There has to be a shorter/easier route than that monster piping all around and wrapped to the front!
If you go straight down from the rear turbo, the filter would be right on top of the downpipes. Probably not the best for cold air intake.
So? Heat shield it and wrap the DP's.... Any of the vendors can get this done with their resources.
I can see this making big numbers considering the increased airflow, less tube, less restrictions and much more user friendly than the above wrapping job.
Probably could be done for approx. $300 - I'd say that's worth the extra 20whp/trq no?