View Single Post
      08-27-2012, 10:10 PM   #9
Chrisred
Captain
 
Chrisred's Avatar
 
Drives: BMW 335xi coupe
Join Date: Jan 2010
Location: Montreal, Canada

Posts: 738
iTrader: (0)

Quote:
Originally Posted by y2khardtop
Are the pads not square across the surface? I would be concerned your calipers have spread if only the outer edge is making full contact. I assume you've bedded them fully? If they can make the surface square, you need to run to another supplier!
Ya did the bed in. From what I see the contact area on rotor is slightly increasing with wear. Guess pad is getting even, still have a long way to go, but its still shorter than rotor width wise. Either way this was a bad job by Endless!!! I'm removing them tmrw. Had them on for two weeks.
__________________
JB4 cp-e IC AMS exhaust BMS DCI AR DP's METH
19" VMR VB3 Stoptech BBK TC KLINE VORSHLAG
Chrisred is offline   Canada
0
Reply With Quote