Originally Posted by 09135ijh
Sorry didn't expand is it just simply extending all wires to trunk?
I followed the directions from multiple post in this thread and had no problem installing my dynavin with no warning symbols.
You are just extending the harness back to the trunk.... And that is it. You might have a bunch of questions, but once you get in there and start digging around, alot of answers should be obvious.
If you are still getting errors after the install and you ran your fiber optics, you prob have a break in the fiber optics loop.
Also there is a place on a panel right below the steering wheel which has the optic cable running to it. Make sure you hook this peice back up. Many people remove this panel to run the wires when installing, and might neglect to hook it back up causing a break in the loop, and causing the errors.