Quote:
Originally Posted by JMARS
HEy guys,
I have an Innovate LC-1 Wideband Controller and I was told that you could feed the LC-1's 0-5v analog output into the Procede's rear o2 sensor input.
So, I know there is a way to hook it up to your Procede harness I just don't know where exactly the rear o2 sensor input would be on the harness.
Any help would be greatly appreciated guys!
|
I was also looking into this with a Dyno tune lean run cut off and was told that the sensors are not compatible to use with a wide band controller. You need to install a totally new 02 sensor with a new bung that outputs 0-5 volts...