View Single Post
      10-04-2012, 05:35 PM   #3

Drives: E90 with 3 pedals
Join Date: Aug 2012
Location: Wilton, CT

iTrader: (0)

I have all of the parts on hand. This is not my first time removing and installing an intake manifold.
I am just wondering if the car will recognize that there are two added DISA valves and utilize them properly. I also just want to make sure that if I flash the 330i software, no sensor, injector,ect.. will become corrupt and that the engine will adjust it's valve timing properly to compensate the different amounts of air entering the engine.

Basically, I just want to know if I will harm my car by loading the 330i software onto it.
I have a workstation set up with DIS, TIS, SSS, INPA, NCS Expert, WinKFP, Tool32 with an K+D CAN interface; PM me if you want to stop by and code your car. ISTA/D + /P with an iCOMM interface finally here!