View Single Post
      10-05-2012, 01:45 PM   #79
ApexRaceParts
BimmerPost Supporting Dealership

 
Drives: M3
Join Date: Jun 2012
Location: Bay Area

Posts: 731
iTrader: (0)

Quote:
Originally Posted by rx7gslse View Post
so to clarify....

Square 17x9 et30 on a 255/40-17 street tirewould fit on a stock sport suspension pre-LCI sedan with only some camber adjustment?

Hmm... your website shows that setup in Hyperblack sold out. Is that a more or less permanant sellout, or would more of these be coming in sometime in the next few months? (I know - this is a tech discussion thread, but while I had you...)
That fitment could very easily be made to work without camber plates. Additional negative camber achieved through pulling the alignment pins on your stock strut mounts should be enough get at most -1.5 degrees and clear the tire. If you do have any front rubbing it would only be the tire just ever so slightly grazing the plastic fender liner. Rear fitment with that set up is very easy and would not need any fender rolling or additional negative camber.

I will send you a pm about color availability.
ApexRaceParts is offline  
0
Reply With Quote