View Single Post
      10-28-2012, 05:35 AM   #5
Efthreeoh
Brigadier General
 
Drives: E90
Join Date: May 2012
Location: MARLAND

Posts: 3,282
iTrader: (0)

Quote:
Originally Posted by AlanAZ View Post
Yep, me too. Saved my butt when I did the filter housing gasket replace, and rounded the e-torx under the manifold with a standard ring spanner (I then had to remove the manifold, hammer on the proper e-torx socket, and wrench it off - I had purchased all new bolts with the gasket.) The only e-torx that I've found that this set wont accommodate is the one at the rear center point for the front strut brace.
I ran into that exact problem too. I think the bolt is an E-18. I used a metric socket (I forget what size) and it worked just fine.
Efthreeoh is offline   United_States
0
Reply With Quote