View Single Post
      11-07-2012, 11:38 PM   #7
igorbmwx6
First Lieutenant
 
igorbmwx6's Avatar
 
Drives: 2011 BMW X6M 5.0 xDrive
Join Date: Jan 2012
Location: San Carlos, CA

Posts: 365
iTrader: (0)

Garage List
Send a message via Skype™ to igorbmwx6
Hi kaigoss69. I have purchased mObridge M1000-M-DA2 for my 09 X5 E70 with, currently, logic 7 (factory) amp, which I am planning to replace with aftermarket McIntosh amps. In any case, could you please send me connection diagram and all recommended voltages. I understand that red (+12V), black (-), what about the blue wire? What voltage (+?). I was trying to update the firmware on it and set it up for my BMW X5; however, I was not able to connect to the unit. Error message appears that most likely there is no power to the unit. What I did, I connected +12V to the red and (-) to the black (from my computer's DC power supply output). Do you think that the problem is with blue wire not connected to anything ??? Thank you in advance.
igorbmwx6 is offline   United_States
0
Reply With Quote