View Single Post
      11-08-2012, 01:37 PM   #11
Joshboody
0
Lieutenant Colonel
 
Drives: pickemuptruck
Join Date: Jul 2009
Location: Phoenix, AZ

Posts: 1,708
iTrader: (7)

Some cars can't have as aggressive tuning as others before they get a low pressure code. You need to fine tune the OL 3D table, boost, AFR, E mix, etc depending on your goals. 3rd gear you'll use more fuel due to meeting boost targets and higher load... this is the gear (or even 4th) you need to use for tuning/logging.

I doubt it's O2... recently I thought I had a "slow" O2, but it ended up being WGs, which were recently changed and now no "slow" O2. 1 WG was doing most of the boost control, so air/fuel had more fluctuation. Likely not your issue though. If O2's are meeting AFR target when trims are good (ie. at part throttle), they should be ok.

BTW, I don't see any logs. You can post logs and even your current map and I (and others) can help walk you through tuning... it would probably be good for many others also.
Joshboody is offline  
Appreciate 0
Reply With Quote