View Single Post
      11-11-2012, 06:42 PM   #14
Kenyale
Registered
0
Rep
2
Posts

 
Drives: BMW 330i
Join Date: Nov 2012
Location: Indpls

iTrader: (0)

Is this a coincidence?

I recently replaced my valve cover gasket on my 2006 330i with the N82 engine. It wasn't easy but I got it done and the problem was solved. Car ran fine after putting everything back together.

Yesterday, I replaced the oil filter housing gasket. The job was fairly easy except I had to partially remove the intake manifold to get to that bolt behind it. Really wasn't that big of a deal but after I put everything back together, the car won't run properly. Starts but idles really rough and evetually stalls. What's puzzling is that the codes indicate a camshaft position sensor problem. I didn't touch that so I am wondering if maybe one or more of the intake manifold gaskets didn't seat properly. Would that cause this problem?

Help!!