View Single Post
      11-17-2012, 12:55 PM   #25

Drives: SGM 335i
Join Date: Jan 2010
Location: Boynton Beach, FL

iTrader: (4)

I haven't had much going on lately as I've had some set backs with parts. I found out the intermediate shaft I needed had to be specifically from a 2.0 16v. I used a 1.8 16v shaft and oil pump drive gear. It's been hell to find those parts as they came in a very short production run, but I finally have some on the way from Canada. The motor has to be pulled out to swap the shafts, so I haven't done anything else since I would just have to take it off. Next weekend I'll be swapping them out and hopefully can get moving on this project again.

I have more goodies that will be going in soon as well:

Summit Racing Aluminum Fuel Cell 15gal
Aeromotive A1000 fuel pump
CXRacing Air to Water intercooler kit
Parts to Fab up a Short Runner intake manifold