Originally Posted by cstavaru
You would put in on the other side of the coolant line, because the TD04 center core is level, so you need a level water line to match. The stock TD03 center core is cast with a lip, such that it matches the existing coolant line perfectly. I hope you get the idea: put the spacer on the other side, not where your arrow is.
And make sure you do NOT tighten the coolant line stud too much !
Thanks for the reply, I am assuming you mean "other side" as the other end (to the block)? Because it seems the built in spacer is welded in....I am probably not understanding correctly here lol!! If the OEM spacer is pressed/welded on how would I get it on the other side of where my Arrow is pointing?
JB4 G5, WEDGE flash, Walbro 455 LPFP, HFS-4 meth kit 4-AN SS lines, BMS OCC, RB turbos W/3.5 N20 sensor, RB valve, BMS DCI, 3" AR Dps, Custom OC W/ SS lines, ER FMIC, ER CP W/HKS BOV, M3 control arms W/upgraded bushings, M3 Strut Brace, M3 front sway, Meyle HD tie-rods, HPA rear toe arms, Wavetrac LSD, DEFIV kit, Ohlins R/T Cois W/12KG swift springs, Power-Flex subframe bushings, stoptech rotors, Rogue Tranny Mounts, Morr VS8.2 rims 245/295