View Single Post
      11-19-2012, 03:45 PM   #2
Technic
Lieutenant General
 
Technic's Avatar
 
Drives: 2012 E92 M3, 2014 528i
Join Date: Apr 2005
Location: Ft Lauderdale, Florida

Posts: 10,851
iTrader: (16)

Garage List
2004 M3  [0.00]
Quote:
Originally Posted by MrRetep View Post
I have the L7 no iDrive in my car. Due to some unforeseen circumstances (blew one of my under seat subs) I decided to do some upgrading.

1. Add in trunk Sub JL Audio W3v3 2ohm powered by a JL Audio JX500/1D this will be mounted in a custom corner box.

2. Replace under seat subs with SWS 8xis. ( I understand that these are not the best for midbass, and I am okay with that) I will be running these off a JL Audio JX250/1. I will wire them in parallel.

3. Technic Harness (Already purchased) The Add a sub wiring is pretty straight forward, no confusion there. Im a bit lost as to how to amp the under seat subs from the harness so if you have some insight I would appreciate it (if not im sure I can figure it out once I have everything.)

So if you guys could give me some feedback/suggestions on this. Id appreciate it. Thanks
The included pig tail (4 12AWG wires) connector is wired to your aftermarket amp outputs -in your particular case, to the JX250-1 amp outputs. Then you plug that pigtail into the harness -there is only one matching 4-wire connector in the harness. No way to plug it any other way.

That's it.
__________________
-2015 F30 320i, Imperial/Oyster, 8AT: August 2014 ED
-2012 E92 M3 Jerez Black/Rust Brown, M-DCT: September 2011 ED
-2008 E90 M3 Melbourne Red/Bamboo, 6MT: Gone
-2007 MK5 GTI United Grey/Grey, DSG: Gone
-2004 E46 M3 Carbon Black/Cinnamon, 6MT: Gone
Technic is offline   United_States
0
Reply With Quote