Had a big hassle that was a stupid simple mistake, Well I figured out why the induction tube did not fit....I installed the gasket on the turbo 1st...induction tube pinched the gasket, it deformed and tube could not be put on. I did not notice this because my hands could not fit back there (it actually felt like it was bound )...I found out because my AEWESOME wife (who has actually helped with this install) saw this...Ii wasted 6 ours on a damn gasket LOL!!
NEVER put the gasket on the turbo...install it in the tube first!
JB4 G5, WEDGE flash, Walbro 455 LPFP, HFS-4 meth kit 4-AN SS lines, BMS OCC, RB turbos W/3.5 N20 sensor, RB valve, BMS DCI, 3" AR Dps, Custom OC W/ SS lines, ER FMIC, ER CP W/HKS BOV, M3 control arms W/upgraded bushings, M3 Strut Brace, M3 front sway, Meyle HD tie-rods, HPA rear toe arms, Wavetrac LSD, DEFIV kit, Ohlins R/T Cois W/12KG swift springs, Power-Flex subframe bushings, stoptech rotors, Rogue Tranny Mounts, Morr VS8.2 rims 245/295