View Single Post
      11-26-2012, 09:36 AM   #6
straightcashhomie
Lieutenant
13

 
straightcashhomie's Avatar
 
Drives: 335i
Join Date: Aug 2012
Location: home


Posts: 547
iTrader: (1)

Quote:
Originally Posted by Reznick View Post
Always always always tighten the lugs or wheel studs with a torque wrench to manufacturer specs and in the pattern they suggest. The pattern typically crisscrosses the wheel in a star figure.You can warp the rotor very easily by not doing this properly. I hate to say it but a lot of dealers and shops just plain old don't care.There are air wrenches that can be set to a torque spec , but that should never be used as a final tightening tool, only to make sure you don't over tighten the studs. Its laziness really because going down through a set of wheels with a torque wrench takes about 5 minutes to go around the whole car once the wheels are on.....My family has owned a heavy equipment sales and service shop for over 30yrs. the HUGE sprockets that drive the tracks on a bulldozer call for torque specs. There are about 50 bolts that need to be torqued to about 300 pounds and then another quarter turn. We do it because that's what it calls for, but I've seen plenty of shop that don't..laziness
Quote:
Originally Posted by zzzbullseye View Post
+1

I always use a torque wrench and would highly recommend their use. A decent torque wrench is relatively inexpensive and helps reduce, if not eliminate, lug related issues.

I've not experienced over-tightening with the dealership, but I suppose it happens, and it's a matter of the diligence of the individual mechanic to spin the lugs on using the proper tools and methods.
Quote:
Originally Posted by morphius909 View Post
Torque it.
Quote:
Originally Posted by jheath View Post
Always hand torque em. Lots of shops don't, they just bang them on forever with an impact. I always do them myself, or if my regular guy does them I am in the shop when he does.
thanks for ur opinions, also what tq wrench r u guys using? How about for Spark Plugs?!