JB4 + G5 installation completed!
I can definitely feel the difference and that's before mixing E85! After installation, I took it for a test drive with map5... (I have BMS DCI only)
first few WOT runs were very impressive until car jerked and threw a code at me. 29F2 - Fuel Pressure....!!
So I pulled over and searched for the code immediately and found out it was a common issue. I guess running map 5 with no E85 mixed is too much...?
So I switched to map1 restarted the car and did few more WOT runs and no codes.
(Keep in mind that I have less than 1000 miles on my 335is)
I'm confused though... I thought G5 was suppose to fix minor code issues..?
Oh and also, when I start up JB4 interface on my computer it does say, "interface settings does not match G5 board"
Was I suppose to update the firmware?