View Single Post
      11-28-2012, 04:13 PM   #16
hellomyBMW
Private First Class
1
Rep
131
Posts

 
Drives: 2013 BMW 335is
Join Date: Nov 2012
Location: Michigan

iTrader: (0)

Garage List
Quote:
Originally Posted by muzzammil15 View Post
I recently installed the G5 board and I love it. I am only running DCI and going from G4 to G5 is a big difference. The smoothness in daily driving is much better, and the car pulls much harder as map5 adapts more and more.
JB4 + G5 installation completed!

I can definitely feel the difference and that's before mixing E85! After installation, I took it for a test drive with map5... (I have BMS DCI only)
first few WOT runs were very impressive until car jerked and threw a code at me. 29F2 - Fuel Pressure....!! I pulled over and searched for the code immediately and found out it was a common issue. I guess running map 5 with no E85 mixed is too much...?
But I was told that you can run map 5 with no mods... ??
So I switched to map1 restarted the car and did few more WOT runs and no codes.
(Keep in mind that I have less than 1000 miles on my 335is so bad fuel pressure is not likely the case...)

I'm confused though... I thought G5 was suppose to fix minor code issues..?
Oh and also, when I start up JB4 interface on my computer it does say, "interface settings does not match G5 board"
Was I suppose to update the firmware?

Please advise!