View Single Post
      11-28-2012, 09:24 PM   #18
muzzammil15
Slurpee anyone?
 
Drives: 07 White 335i
Join Date: Dec 2011
Location: VA beach

Posts: 597
iTrader: (3)

Send a message via MSN to muzzammil15
Quote:
Originally Posted by hellomyBMW View Post
JB4 + G5 installation completed!

I can definitely feel the difference and that's before mixing E85! After installation, I took it for a test drive with map5... (I have BMS DCI only)
first few WOT runs were very impressive until car jerked and threw a code at me. 29F2 - Fuel Pressure....!! I pulled over and searched for the code immediately and found out it was a common issue. I guess running map 5 with no E85 mixed is too much...?
But I was told that you can run map 5 with no mods... ??
So I switched to map1 restarted the car and did few more WOT runs and no codes.
(Keep in mind that I have less than 1000 miles on my 335is so bad fuel pressure is not likely the case...)

I'm confused though... I thought G5 was suppose to fix minor code issues..?
Oh and also, when I start up JB4 interface on my computer it does say, "interface settings does not match G5 board"
Was I suppose to update the firmware?

Please advise!
http://www.n54tech.com/forums/forumdisplay.php?f=3

Post and read up on here and most of your questions will be answered. I only have DCI as well, but I have not gotten that code. I have done a few pulls myself, and it seems to get better every time. Only thing is when the car is cold, it shifts a bit rough. After warming up it gets better.
__________________
Ghetto mods central!!

muzzammil15 is offline   United_States
0
Reply With Quote