Originally Posted by Joe-
You didn't replace the screws? BMW recommends replacement of the screws, claims you will be replacing the gasket again later on with the screws because the screws will loosen and cause leak. What was Rob Becks Recommendation on this?
Don't see that happening, unless you damage them. BMW master teck said the same. Said he only replaces screws if they are damaged. You have to figure, these are but in with only 7-7.5 lbs of torque...only way they can really come loose is if the threads are damaged. My dealer didn't even carry them, they are included with a new valve cover and so is the gasket.
None of my bolts where painted "blue" wich indicated a replacement bolt except the ones holding the wire holder oddly enough.
JB4 G5, WEDGE flash, Walbro 455 LPFP, HFS-4 meth kit 4-AN SS lines, BMS OCC, RB turbos W/3.5 N20 sensor, RB valve, BMS DCI, 3" AR Dps, Custom OC W/ SS lines, ER FMIC, ER CP W/HKS BOV, M3 control arms W/upgraded bushings, M3 Strut Brace, M3 front sway, Meyle HD tie-rods, HPA rear toe arms, Wavetrac LSD, DEFIV kit, Ohlins R/T Cois W/12KG swift springs, Power-Flex subframe bushings, stoptech rotors, Rogue Tranny Mounts, Morr VS8.2 rims 245/295