View Single Post
      11-30-2012, 10:14 PM   #4
BimmerPost Supporting Vendor

cn555ic's Avatar
Drives: 917-939-4980
Join Date: Jun 2007
Location: New York

Posts: 18,266
iTrader: (5)

Send a message via Yahoo to cn555ic
I used INPA and used Measurement Block 6 readings which has a LP sensor reading. A normal sensor should be running at ~5000 Hpa. Mine was pegged 7403 but it didn't fluctuate at all which it suppose to. Here is my thread on it. I originally thought for sure it was a HPFP issue. I honestly think you caught a bad break a installed a brand new sensor that is defective..If it was my car I would try and get another one and install it onto the car and see if this get rid of the code once and for all...

Coding E and F New York 917-939-4980

Last edited by cn555ic; 11-30-2012 at 10:37 PM.
cn555ic is offline   United_States
Reply With Quote