View Single Post
      12-04-2012, 02:58 PM   #50
BigBoosting
First Lieutenant
5
Rep
356
Posts

 
Drives: 09' M3 6MT
Join Date: Aug 2012
Location: Savannah

iTrader: (2)

Quote:
Originally Posted by Tzu View Post
Biasing works both ways. Set the cells, say, 60 across and see if your AFR bumps up ~0.8 across the board. Not sure if the DME limits for rich/lean conditions are different before intervention, but its worth a try. I would NOT set it any more than 10 points either way in the bias map, but worth a try. If it does enlean the AFRs by ~0.8ish after a couple pulls, then its definately your flash likely being set up for gas. Althoguh IMO it sounds like it already, but if you want to put a nail in the coffin.

Edit: before doing any of the above, post of log with fuel correction so we can see that the procede is actually applying no bias at all. I'll never reccomend intentionally going lean (0.8 above 11 is acceptable) but for any other people who find this post and think its acceptable, its generally not.
I was thinking of doing just that. So I could get more logs to send in and show there is a problem.

I checked the correction and I am pretty sure it was flat with no correction. I will double check again before any new changes.

Last edited by BigBoosting; 12-04-2012 at 03:07 PM.